Home - Brands - Clevite
Click on image to zoom

Clevite GM/LS SBC H-Series Tri-Armor Rod Bearings

C77-CB-663HN
H Series

Performance Bearing

Tri-Armor Coated

Choose Your Size

Tri Metal, TM 77
Pricing: $109.95

Customize Your Item

- Clevite LS/SBC Coated H-Series R -
 * required
Qty:

Description

They have hardened-steel backings with thin overlays and a high crush factor, plus a medium level of eccentricity. They also have enlarged chamfers at the sides for greater crank-fillet clearance and are made without flash plating for better seating.

Specifications/Information

1962-10 (4.8/5.3/5.7/6.0/6.2L) V8 Engines

Clevite Fitment Guide

H Series -
  • Best to start with when unsure which bearing to choose
  • Medium level of eccentricity and high crush
  • Enlarged chamfers for greater crankshaft fillet clearance
  • Made without flash plating for better seating
  • Use with crankshafts that have oversized fillets
  • Use with engines that run mid-high RPM range
  • Contact patterns should ideally cover 2/3 to 3/4 of the bearing surface

    P Series -
  • Typically the greatest level of eccentricity
  • Rods and mains have high crush for maximum retention
  • Most are fully grooved to maximize oil flow to rod bearings
  • Reduced overlay thickness to prevent overlay fatigue
  • Use where extremely high RPMs cause severe rod bore close-in
  • Use where higher eccentricity is desired to narrow bearing contact patterns

    V Series
     -
  • This series essentially duplicates Clevite's former Vandervell parts
  • Typically low to medium eccentricity
  • Not available with oversized chamfers
  • No flash plating on the steel back
  • All Clevite main bearing sets use a single-piece thrust bearing
  • Narrowed parts available to accommodate increased crankshaft fillet clearance
  • Lead-indium overlay offers slightly better conformability

    M Series
     -
  • These are special purpose bearings having a nominal .005" thick Babbitt lining on a hardened steel back
  • They are intended mainly for Blown Fuel engines where severe crankshaft deflections cause edge loading of the bearings
  • Under these operating conditions bearing service life will be very short
  • Frequent inspection and replacement is recommended 


    Part Number Key
    • H - High-Performance
    • HD - High-Performance bearing with dowel hole
    • HK - High-Performance bearing with moly/graphite coating
    • P - Standard Clevite 77 tri-metal bearing
    • M - Blown Fuel Engine bearing for severe crankshaft deflections & edge loading
    • N - High-Performance Narrowed for greater crankshaft fillet clearance
    • HG - High-Performance full angular grooved bearing
    • V - High-Performance with Lead Indium overlay (On Main Sets this indicates partial groove also)
    • VG - High-Performance with Lead Indium full angular grooved bearing
    • D - Bearing has a dowel hole
    • K - Tri-Armor coated bearing
    • X - Bearing has .001 more oil clearance than standard
    • XX - Bearing has .002 more oil clearance than standard
    • A or AL - Indicates Aluminum bearing material

Details

Shipping Information

  • Item Requires Shipping

Customer Reviews

Comment Total Reviews (0)

Write the First Review!

You must login to post a review.